ProTech Tools


    ProTech® Password Clearing Tool resets the ProTech Module passwords (Test and Configure) back to the factory defaults.

    Supports the following firmware part numbers:

    5418-8087 rev - (Guardian SDS); 5418-7912 rev -, A (Guardian ODS); 5418-7349 rev -, A (Math Enhancements); 5418-7350 rev -, A (Math Enhancements); 5418-7351 rev -, A (Math Enhancements); 5418-6349 rev NEW, A, B (Voted Inputs); 5418-7000 rev NEW, A, B (Voted Inputs);5418-6348 rev NEW, A, B (Voted Inputs); 5418-6347 rev NEW, A (Voted Inputs); 5418-6274 rev NEW, A; 5418-6273 rev NEW, A; 5418-3827 NEW, A, B; 5418-3794 NEW, A, B; 5418-3654 rev A, B, C; 5418-3630 rev A, B, C.

    System Requirements:

    • Microsoft Windows®  11, 10, 8.1, 7.
    • Microsoft .NET Framework version 4.7.2
    • Woodward ToolKit® version 6.5.1 or higher
    • 1 GHz or faster x86 or x64 processor
    • 1GB of RAM
    • Minimum 1024 by 768 pixel screen resolution
    • 9 pin-D Serial Port (RS232)
    • 9 pin-D straight through Serial Cable (not a null modem cable) 

    Service Tool requires that the Microsoft .NET Framework be installed. The Service Tool installation will attempt to install the .NET Framework from the Internet; but you can also obtain the .NET Framework Redistributable package from the link below.

    Click here for the .NET Framework Redistributable Package.

    Installation Instructions:

    1. The first step in installing this software is to download the file from this page. This file is an installation program that will step you through the installation process.
    2. After downloading this file, run it and follow the instructions on the setup dialogs.



    ProTech Tools
    26.5 MB